Multi Rack Ovens

Revent 703 Multi Rack Oven

Revent 703 Multi Rack Oven

  • Revent TCC System
  • Revent HVS System
  • Revent LID System
  • Revent High Efficiency Heat Exchanger
  • Revent Wedge Installation System
  • Stainless Steel Design
  • Digital Control Panel
  • Automatic Steam Control
  • 2010 Model with smaller footprint
    available from September

UTILITY REQUIREMENTS

Electrical

Electrical: available in 3-phase voltages

Water and Drain

Water Supply: G½"ø 4,5 kg/cm² (450 kPa)

Drain: 1" connection (optional connection to front or rear)

Ventilation

Oven Pressure Duct: ø 160 mm (right rear corner of oven chamber)
Oven Damper Exhaust: ø 136 (right rear corner of oven chamber)
Oven Stack Exhaust: ø 250mm (oil and gas versions only)
Canopy Port: ø 300 mm (on optional 600 series canopy)

Technical information

Maximum Heat Capacity: see table
Temperature range: 50-300°C
Total shipping weight: 3360 kgs*
Minimum intake opening: 1220x2380mm
(standard 3 section delivery)
Minimum intake opening: 2320x2500mm
(optional - one piece shipment)
Minimum section tilt up height: 3500mm
Swing diameter: 1950mm
Max load of platform 800 kg
Steam Generation 11 l/20 sec

Revent 723 Electrically heated maximum capacity table Revent 723 Oil / gas heated maximum capacity table

Installation requirements

The oven must be installed on a level, non-combustible floor. The oven may be installed flush against any wall - only the front and top need to be left open for access. The space on top of the oven must be well ventilated and the temperature must not exceed 50°C. This is to avoid damage to electrical components.

Click to download PDF, detailing our complete range of ovens